The PSU was probably the most complicated mod in this project. It took an incredible ammount of planning and brainstorming. The work was also very taxing and tedious. Nevertheless, i enjoyed it and managed to get it done.

The PSU's entire method of distributing power was modified. Instead of the power cables leaving the PSU and plugging into the components in the machine, the cables were run into junction boxes which were used to distribute the power throughout the machine. This method allowed me to multiply the cables to the extent that i wanted and it was also very aesthetically pleasing.

The PSU cover was chromed to fit in with the case's theme:

I then had to start lengthening the 24 wires for the ATX plug and the other four wires for the 4 pin ATX plug:

My table was a mess:

Finished lengthening those cables:

Here's some of the planning i did for the junction boxes: